The DPA616 is a professional sixteen channel power amplifier which is capable of delivering a power of 60 Watt to 4 Ohm loads connected to the 16 output channels. When used in bridge mode, it can deliver a power of 120 Watt to 8 Ohm loads connected to the 8 bridged outputs. This way, the DPA616 is the perfect solution for installed multi-zone audio distribution systems with 8 or 16 zones. This amplifier is designed as a no-nonsense amplifier with only the necessary controls and connections which creates great simplicity in use and installation. The input connections are all performed with 3-pin Terminal block connectors, allowing the connection of balanced input signals. Every channel is fitted with a separate gain control potentiometer and for every two input connectors, there is a stereo / bridge & parallel switch provided whereby two channels can be bridged or linked in parallel, avoiding a cable clutter when multiple channels should be fed with the same input signal. The output connections are performed with 4-pin Terminal block connectors allowing connections for separate or bridged output channels. A built-in multipurpose protection circuit protects against DC malfunction, short circuit, overheating, overload and limits the signal when necessary. This all is housed in a double rack space, steel 19” rack mount housing.
|Frequency||Response (± 3 dB)||20 Hz - 20 kHz|
|Signal / Noise||> 100 dB|
|THD+N (@ 1 kHz)||< 0.1%|
|Inputs||Sensitivity||-20 dB ~ +20 dB|
|Connector||3-pin Euro Terminal Block (Pitch - 3.81 mm)|
|Outputs||Connector||4-pin Euro Terminal Block (Pitch - 5.08 mm)|
|Source||100 ~ 240 V AC / 50 ~ 60 Hz|
|Protection||DC Short circuit|
|Operating temperature||0° ~ 40° @ 95% Humidity|
|RMS/AES power handling||@ 4 Ω Stereo||16 x 60 W|
|@ 8 Ω Bridge||8 x 120 W|
|@ 8 Ω Stereo||16 x 30 W|
|Dimensions||18.98 x 3.46 x 12.68 " (W x H x D)|
|Unit height||2 HE|
|Accessories||Included||16 x 3-pin Euro Terminal Block Input connectors|
|8 x 4-pin Euro Terminal Block outputs connector|
Bars & Restaurants
As the power consumption of an amplifier, strongly depends on how hard the amplifier is driven, measurements are provided for various loads: idle, 1/8 of average full power, 1/3 of average full power, and full power.
Current draw at idle or with very low signal level
1/8 Power: Pink Noise
Amplifiers are tested using pink noise signals to simulate real-world speech and music signals. It approximates operating with music or voice with light clipping and represents the amplifier's typical "clean" maximum level, without audible clipping. This 1/8 power signal provides a very good approximation of how hard an amplifier would be driven by typical real-world speech/music signals, assuming those signals were being driven as loud as possible without clipping the amplifier.
1/3 Power: Pink Noise
1/3 Power Pink Noise is similar to 1/8 Power Pink Noise, except that it is a significantly more powerful input signal. It approximates operating with music or voice with very heavy clipping and a very compressed dynamic range. This 1/3 power signal provides an approximation of how hard an amplifier would be driven by typical real-world speech/music signals, assuming those signals were being driven loud enough to clip the amplifier heavily, and produce severe, audible distortion.
Current draw at full power is measured with a sine wave at its maximum possible level. However, it does not represent any real-world operating condition and represents the absolute extremes that an amplifier could ever experience.